GASKET DOOR hinge OVEN ANGELO PO 720 mm

GASKET DOOR HINGE OVEN ANGELO PO

General Info:
in the silicone elastomer
profile dimensions 41x22 mm
COLOR BLACK

For: ANGELO PO convection Oven electric FX202E2, FX202E3, FX202E3-ZND02
ANGELO PO convection Oven gas FX202G2, FX202G3

Adaptability:
MANUFACTURER CODE
3199580 ANGELO PO
3199580 SAGI

Sales and spare Parts gaskets for oven door convection electric convection gas Angelo Po

Instructions and tips for the replacement/installation of the seals:

1) Remove the old seal from its seat

2) thoroughly Clean all of the debris and dirt both from the throat-snap-fit on the bearing surface with specific detergents

3) In the event of difficulties in inserting the gasket in the joint spraying/wetting with liquid soap

4) Mount the gasket starting from the corners in the sequence: (as in photo 1)

- First mount the 4 corners A-A1, B-B1

- Then the center between the points C-C1

- Now push the rest of the gasket starting from the center to the points C-C1 and D-D1

*CAUTION: if the seal has a hole, air vent, the side with the hole must be mounted in the bottom (as in photo 2)

*IMPORTANT: CHECK DOOR SEAL

- If the gasket is mounted correctly, steam should not result in a loss of steam

- In the "combi steam" to 300C, the door must be closed properly. Otherwise an adjustment is needed of the door.

Care and repeated cleaning during the day, greatly extend the life of the seals.