DOOR GASKET OVEN RATIONAL 1475x475 mm

DOOR GASKET OVEN RATIONAL

General Info:
in the silicone elastomer
profile dimensions 27x17 mm
BLUE COLOR

To: RATIONAL Oven convection electric CM 201 - WE PLUS, CM 201, AND 200V 50-60Hz, CM 201, AND 208V 60Hz, CM 201 E 400V 50-60Hz, SCC 201, SCC 201, AND WE, SCC 201 AND 200V 50-60Hz, SCC 201 AND 208V 60Hz, SCC 201 E 400V 50-06Hz
RATIONAL convection Oven gas, CM 201 G, CM 201 G - WE PLUS, CM 201 G 100V 50-60Hz, CM 201 G 120V 60Hz, SCC 201 G, SCC 201 G - WE, SCC 201 G 100V 50-60Hz, SCC 201 G 120V 60Hz, SCC 201 G 230V 50-60Hz

Adaptability:
MANUFACTURER CODE
RT2000398P FAGOR
2000398 FRIMA
2000398P FRIMA
2000398 METOS
2000398P METOS
2000398 RATIONAL
2000398P RATIONAL

Instructions and tips for the replacement/installation of the seals:

1) Remove the old seal from its seat

2) thoroughly Clean all of the debris and dirt both from the throat-snap-fit on the bearing surface with specific detergents

3) In the event of difficulties in inserting the gasket in the joint spraying/wetting with liquid soap

4) Mount the gasket starting from the corners in the sequence: (as in photo 1)

- First mount the 4 corners A-A1, B-B1

- Then the center between the points C-C1

- Now push the rest of the gasket starting from the center to the points C-C1 and D-D1

*CAUTION: if the seal has a hole, air vent, the side with the hole must be mounted in the bottom (as in photo 2)

*IMPORTANT: CHECK DOOR SEAL

- If the gasket is mounted correctly, steam should not result in a loss of steam

- In the "combi steam" to 300C, the door must be closed properly. Otherwise an adjustment is needed of the door.

Care and repeated cleaning during the day, greatly extend the life of the seals.