DOOR GASKET OVEN ELOMA/PALUX 700x650 mm

DOOR GASKET OVEN ELOMA/PALUX

General Info:
in the silicone elastomer
profile dimensions 29x24 mm
COLOR BLACK

For ELOMA convection Oven EDA 10-11, MD 10-11, MD 6-11 MMC 10-11, MMC 6-11, MMD 10-11, MMD 6-11
ELOMA convection Oven electric EDA 6-11, EDB 10-11, EDB 6-11, EDC 10-11, EDC 6-11, ELH 10-1, ELH 5-1, ELH 5-3, ELH 6-1
ELOMA convection Oven gas MMC 10-11 GAS MMD 10-11 GAS
PALUX Oven convection electric ECS-ECA-ECP-611-1011
PALUX Oven convection gas ECA-ECP-1011-GAS

Adaptability:
MANUFACTURER CODE
382310 ECM
382310 ELOMA
425033 ELOMA
1L295593 FRANKE
382310 FRANKE
295593F RANKE
382310 PALUX

We have available all models of gaskets for oven door ELOMA/PALUX for industrial kitchens professional

Instructions and tips for the replacement/installation of the seals:

1) Remove the old seal from its seat

2) thoroughly Clean all of the debris and dirt both from the throat-snap-fit on the bearing surface with specific detergents

3) In the event of difficulties in inserting the gasket in the joint spraying/wetting with liquid soap

4) Mount the gasket starting from the corners in the sequence: (as in photo 1)

- First mount the 4 corners A-A1, B-B1

- Then the center between the points C-C1

- Now push the rest of the gasket starting from the center to the points C-C1 and D-D1

*CAUTION: if the seal has a hole, air vent, the side with the hole must be mounted in the bottom (as in photo 2)

*IMPORTANT: CHECK DOOR SEAL

- If the gasket is mounted correctly, steam should not result in a loss of steam

- In the "combi steam" to 300C, the door must be closed properly. Otherwise an adjustment is needed of the door.

Care and repeated cleaning during the day, greatly extend the life of the seals.