SEAL GLASS OVEN HOBART 2000 mm

SEAL GLASS OVEN HOBART

General Info:
in the silicone elastomer
profile dimensions 18x12 mm
COLOR BLACK

For HOBART convection Oven CSM-UC
HOBART convection Oven electric CS0612E, CSD 0612 E, the CSD AND CSD-UC, CSE, CSL06E, CSL10E, CSM0611IE, CSM1011IE, CSM1021IE, CSM2011IE, CSM2021IE, HCSM-UC 0612, HCSM-UC 0612R, WCL0612E
HOBART Oven electric steam WCSL0612E, WCSL1012E, WCSL1022E, WCSL2012E

Adaptability:
MANUFACTURER CODE
00-845052-000HOBART
845052HOBART
492439HOBART

Sales and spare Parts gaskets for oven door convection electric convection gas HOBART

Instructions and tips for the replacement/installation of the seals:

1) Remove the old seal from its seat

2) thoroughly Clean all of the debris and dirt both from the throat-snap-fit on the bearing surface with specific detergents

3) In the event of difficulties in inserting the gasket in the joint spraying/wetting with liquid soap

4) Mount the gasket starting from the corners in the sequence: (as in photo 1)

- First mount the 4 corners A-A1, B-B1

- Then the center between the points C-C1

- Now push the rest of the gasket starting from the center to the points C-C1 and D-D1

*CAUTION: if the seal has a hole, air vent, the side with the hole must be mounted in the bottom (as in photo 2)

*IMPORTANT: CHECK DOOR SEAL

- If the gasket is mounted correctly, steam should not result in a loss of steam

- In the "combi steam" to 300C, the door must be closed properly. Otherwise an adjustment is needed of the door.

Care and repeated cleaning during the day, greatly extend the life of the seals.