DOOR GASKET OVEN ANGELO PO 410x330 mm

DOOR GASKET OVEN ANGELO PO

General Info:
in the silicone elastomer
profile size 21x17 mm
COLOR BLACK

For: ANGELO PO convection Oven electric FCV3EM, FCV4E, FCV4EDS, FCV4EM, FM423E1, FM423E2

Adaptability:
MANUFACTURER CODE
37Q4980 ANGELO PO
37Q4980 SAGI

Availability the door seals and oven-professional ovens and industrial to restaurants and kitchens, ovens, pizza convection ovens, electric

Instructions and tips for the replacement/installation of the seals:

1) Remove the old seal from its seat

2) thoroughly Clean all of the debris and dirt both from the throat-snap-fit on the bearing surface with specific detergents

3) In the event of difficulties in inserting the gasket in the joint spraying/wetting with liquid soap

4) Mount the gasket starting from the corners in the sequence: (as in photo 1)

- First mount the 4 corners A-A1, B-B1

- Then the center between the points C-C1

- Now push the rest of the gasket starting from the center to the points C-C1 and D-D1

*CAUTION: if the seal has a hole, air vent, the side with the hole must be mounted in the bottom (as in photo 2)

*IMPORTANT: CHECK DOOR SEAL

- If the gasket is mounted correctly, steam should not result in a loss of steam

- In the "combi steam" to 300C, the door must be closed properly. Otherwise an adjustment is needed of the door.

Care and repeated cleaning during the day, greatly extend the life of the seals.