DOOR GASKET OVEN ANGELO PO
General Info:
in the silicone elastomer
profile dimensions 25,2/23,5x22 mm
COLOR BLACK
For: ANGELO PO convection Oven electric FC241E, FCV241E, FCV241EDM, FCV241EDS
ANGELO PO convection Oven gas FC241G, FCV241G, FCV241GDM, FCV241GDS
Adaptability:
MANUFACTURER CODE
37Q0990 ANGELO PO
37Q0991 ANGELO PO
37Q0992 ANGELO PO
37Q0990 SAGI
37Q0991 SAGI
37Q0992 SAGI
In this category you can find all the models of gaskets for oven door for cooking facilities professional of the brand Angelo Po
Instructions and tips for the replacement/installation of the seals:
1) Remove the old seal from its seat
2) thoroughly Clean all of the debris and dirt both from the throat-snap-fit on the bearing surface with specific detergents
3) In the event of difficulties in inserting the gasket in the joint spraying/wetting with liquid soap
4) Mount the gasket starting from the corners in the sequence: (as in photo 1)
- First mount the 4 corners A-A1, B-B1
- Then the center between the points C-C1
- Now push the rest of the gasket starting from the center to the points C-C1 and D-D1
*CAUTION: if the seal has a hole, air vent, the side with the hole must be mounted in the bottom (as in photo 2)
*IMPORTANT: CHECK DOOR SEAL
- If the gasket is mounted correctly, steam should not result in a loss of steam
- In the "combi steam" to 300C, the door must be closed properly. Otherwise an adjustment is needed of the door.
Care and repeated cleaning during the day, greatly extend the life of the seals.