DOOR GASKET OVEN ANGELO PO 485x485 mm

DOOR GASKET OVEN ANGELO PO

General Info:
in the silicone elastomer
profile dimensions of 19.3/12x24 mm
COLOR BLACK

For: ANGELO PO convection Oven electric FC611E, FM611E1, FM611E2, FM611E3
ANGELO PO convection Oven gas FC611G, FM611G1, FM611G2, FM611G3

Adaptability:
MANUFACTURER CODE
36E3030 ANGELO PO
36E3031 ANGELO PO
36E3030 SAGI
36E3031 SAGI

We have available all models of gaskets for oven door Angelo Po for professional kitchens

Instructions and tips for the replacement/installation of the seals:

1) Remove the old seal from its seat

2) thoroughly Clean all of the debris and dirt both from the throat-snap-fit on the bearing surface with specific detergents

3) In the event of difficulties in inserting the gasket in the joint spraying/wetting with liquid soap

4) Mount the gasket starting from the corners in the sequence: (as in photo 1)

- First mount the 4 corners A-A1, B-B1

- Then the center between the points C-C1

- Now push the rest of the gasket starting from the center to the points C-C1 and D-D1

*CAUTION: if the seal has a hole, air vent, the side with the hole must be mounted in the bottom (as in photo 2)

*IMPORTANT: CHECK DOOR SEAL

- If the gasket is mounted correctly, steam should not result in a loss of steam

- In the "combi steam" to 300C, the door must be closed properly. Otherwise an adjustment is needed of the door.

Care and repeated cleaning during the day, greatly extend the life of the seals.