DOOR GASKET OVEN MORICE 808x635 mm

DOOR GASKET OVEN MORICE

General Info:
in the silicone elastomer
profile dimensions 33x13 mm
COLOR BLACK

For: CONVOTHERM convection Oven OD10.20
CONVOTHERM convection Oven electric OD10.20, OD10.20 RA, OD10.20 VST, OS10.20, OSC10.20

Adaptability:
MANUFACTURER CODE
7001032 CONVOTHERM

WE MAKE TO MEASURE AND WE SELL GASKETS FOR OVEN DOOR MORICE FOR INDUSTRIAL KITCHENS PROFESSIONAL

Instructions and tips for the replacement/installation of the seals:

1) Remove the old seal from its seat

2) thoroughly Clean all of the debris and dirt both from the throat-snap-fit on the bearing surface with specific detergents

3) In the event of difficulties in inserting the gasket in the joint spraying/wetting with liquid soap

4) Mount the gasket starting from the corners in the sequence: (as in photo 1)

- First mount the 4 corners A-A1, B-B1

- Then the center between the points C-C1

- Now push the rest of the gasket starting from the center to the points C-C1 and D-D1

*CAUTION: if the seal has a hole, air vent, the side with the hole must be mounted in the bottom (as in photo 2)

*IMPORTANT: CHECK DOOR SEAL

- If the gasket is mounted correctly, steam should not result in a loss of steam

- In the "combi steam" to 300C, the door must be closed properly. Otherwise an adjustment is needed of the door.

Care and repeated cleaning during the day, greatly extend the life of the seals.