DOOR GASKET OVEN PALUX
General Info:
in the silicone elastomer
profile dimensions 30 x 20 mm
COLOR BLACK
For ELOMA convection Oven electric BUT the GENIUS 10-11, BUT GENIUS 20-11, BUT the GENIUS 6-11, BUT-KT GENIUS 10-11, BUT-KT GENIUS 20-11, BUT-KT GENIUS 6-11, MB GENIUS 10-11, MB GENIUS 20-11, MB GENIUS 6-11, MB GENIUS GAS 20-11
ELOMA convection Oven gas BUT the GENIUS GAS 10-11, BUT GENIUS GAS 20-11, BUT the GENIUS GAS 6-11, MB GENIUS GAS 10-11, MB GENIUS GAS 6-11
Adaptability:
MANUFACTURER CODE
2000214 ELOMA
EL2000214 ELOMA
742384 ELOMA
RX94820002 ROSINOX
We have available all models of gaskets for oven door PALUX for industrial kitchens professional
Instructions and tips for the replacement/installation of the seals:
1) Remove the old seal from its seat
2) thoroughly Clean all of the debris and dirt both from the throat-snap-fit on the bearing surface with specific detergents
3) In the event of difficulties in inserting the gasket in the joint spraying/wetting with liquid soap
4) Mount the gasket starting from the corners in the sequence: (as in photo 1)
- First mount the 4 corners A-A1, B-B1
- Then the center between the points C-C1
- Now push the rest of the gasket starting from the center to the points C-C1 and D-D1
*CAUTION: if the seal has a hole, air vent, the side with the hole must be mounted in the bottom (as in photo 2)
*IMPORTANT: CHECK DOOR SEAL
- If the gasket is mounted correctly, steam should not result in a loss of steam
- In the "combi steam" to 300C, the door must be closed properly. Otherwise an adjustment is needed of the door.
Care and repeated cleaning during the day, greatly extend the life of the seals.