SEAL GLASS OVEN INTERNAL FAGOR

SEAL GLASS OVEN INTERNAL FAGOR

General Info:
in the silicone elastomer
profile dimensions 12x10 mm
COLOR GREY
SALES PER LINEAR METER

For: FAGOR convection Oven electric HMM-10-11, HMM-10-21
FAGOR convection Oven gas (HCG-10-11
FAGOR Oven sottocucina electric HMI-1011, HMI-1021, HMI-611, HMM-1011, HMM-1021, HMM-611

Adaptability:
MANUFACTURER CODE
11000173 FAGOR
3713700000 FAGOR
R680515000 FAGOR
R660500000 FAGOR
R670529000 FAGOR
VAUBAN

Tailor-made and sell the door seals and oven FAGOR for professional kitchens of the best brands.

Instructions and tips for the replacement/installation of the seals:

1) Remove the old seal from its seat

2) thoroughly Clean all of the debris and dirt both from the throat-snap-fit on the bearing surface with specific detergents

3) In the event of difficulties in inserting the gasket in the joint spraying/wetting with liquid soap

4) Mount the gasket starting from the corners in the sequence: (as in photo 1)

- First mount the 4 corners A-A1, B-B1

- Then the center between the points C-C1

- Now push the rest of the gasket starting from the center to the points C-C1 and D-D1

*CAUTION: if the seal has a hole, air vent, the side with the hole must be mounted in the bottom (as in photo 2)

*IMPORTANT: CHECK DOOR SEAL

- If the gasket is mounted correctly, steam should not result in a loss of steam

- In the "combi steam" to 300C, the door must be closed properly. Otherwise an adjustment is needed of the door.

Care and repeated cleaning during the day, greatly extend the life of the seals.