SEAL GLASS OVEN INTERNAL CONVOTHERM - 5 mt

SEAL GLASS OVEN INTERNAL CONVOTHERM

General Info:
in the silicone elastomer
profile size 8,5x7 mm
COLOR BLACK

For: CONVOTHERM convection Oven OD12.20
CONVOTHERM convection Oven electric OD12.20 RA, OD12.20 VST, OD20.10, OD20.10 RA, OD20.20, OD20.20 RA, OD20.20 VST, OD6.10

Adaptability:
MANUFACTURER CODE
7001041 CONVOTHERM

Sales and spare Parts gaskets for oven door CONVOTHERM for gastronomy, bakery and pastry

Instructions and tips for the replacement/installation of the seals:

1) Remove the old seal from its seat

2) thoroughly Clean all of the debris and dirt both from the throat-snap-fit on the bearing surface with specific detergents

3) In the event of difficulties in inserting the gasket in the joint spraying/wetting with liquid soap

4) Mount the gasket starting from the corners in the sequence: (as in photo 1)

- First mount the 4 corners A-A1, B-B1

- Then the center between the points C-C1

- Now push the rest of the gasket starting from the center to the points C-C1 and D-D1

*CAUTION: if the seal has a hole, air vent, the side with the hole must be mounted in the bottom (as in photo 2)

*IMPORTANT: CHECK DOOR SEAL

- If the gasket is mounted correctly, steam should not result in a loss of steam

- In the "combi steam" to 300C, the door must be closed properly. Otherwise an adjustment is needed of the door.

Care and repeated cleaning during the day, greatly extend the life of the seals.