SEAL GLASS OVEN ELOMA - 6 mt

SEAL GLASS OVEN ELOMA

General Info:
in the silicone elastomer
profile size 13,5x10 mm
COLOR GREY

For ELOMA convection Oven MD 10-11, MD 6-11 MMC 10-11, MMC 6-11, MMD 10-11, MMD 6-11
ELOMA convection Oven electric EBM4, EBM5, ELH 10-1, ELH 5-1, ELH 5-3, ELH 6-1, MD 20-11, MD 20-21, MMD 20-11, MMD 20-21
ELOMA convection Oven gas MMC 10-11 GAS MMD 10-11 GAS

Adaptability:
MANUFACTURER CODE
H0515 ELOMA
425041 ELOMA

Tailor-made and sell the door seals and oven ELOMA for professional kitchens of the best brands.

Instructions and tips for the replacement/installation of the seals:

1) Remove the old seal from its seat

2) thoroughly Clean all of the debris and dirt both from the throat-snap-fit on the bearing surface with specific detergents

3) In the event of difficulties in inserting the gasket in the joint spraying/wetting with liquid soap

4) Mount the gasket starting from the corners in the sequence: (as in photo 1)

- First mount the 4 corners A-A1, B-B1

- Then the center between the points C-C1

- Now push the rest of the gasket starting from the center to the points C-C1 and D-D1

*CAUTION: if the seal has a hole, air vent, the side with the hole must be mounted in the bottom (as in photo 2)

*IMPORTANT: CHECK DOOR SEAL

- If the gasket is mounted correctly, steam should not result in a loss of steam

- In the "combi steam" to 300C, the door must be closed properly. Otherwise an adjustment is needed of the door.

Care and repeated cleaning during the day, greatly extend the life of the seals.