SEAL GLASS OVEN ANGELO PO
General Info:
in the silicone elastomer
profile dimensions 13x12 mm
welded - COLOUR BLACK
For: ANGELO PO convection Oven electric FC101E, FCV101E, FCV101EDM, FCV101EDS
ANGELO PO convection Oven gas FC101, FCV101, FCV101DM, FCV101DS
CONVOTHERM convection Oven electric OD10.10
CONVOTHERM convection Oven gas OD10.10 GE, OSG10.10, OSG6.10
Adaptability:
MANUFACTURER CODE
37Q2991 ANGELO PO
37Q2992 ANGELO PO
7001045 CONVOTHERM
37Q2991 SAGI
37Q2992 SAGI
Sales and spare Parts gaskets for oven door convection electric convection gas Angelo Po
Instructions and tips for the replacement/installation of the seals:
1) Remove the old seal from its seat
2) thoroughly Clean all of the debris and dirt both from the throat-snap-fit on the bearing surface with specific detergents
3) In the event of difficulties in inserting the gasket in the joint spraying/wetting with liquid soap
4) Mount the gasket starting from the corners in the sequence: (as in photo 1)
- First mount the 4 corners A-A1, B-B1
- Then the center between the points C-C1
- Now push the rest of the gasket starting from the center to the points C-C1 and D-D1
*CAUTION: if the seal has a hole, air vent, the side with the hole must be mounted in the bottom (as in photo 2)
*IMPORTANT: CHECK DOOR SEAL
- If the gasket is mounted correctly, steam should not result in a loss of steam
- In the "combi steam" to 300C, the door must be closed properly. Otherwise an adjustment is needed of the door.
Care and repeated cleaning during the day, greatly extend the life of the seals.