SEAL GLASS OVEN ANGELO PO 2100 mm

SEAL GLASS OVEN ANGELO PO

General Info:
in the silicone elastomer
profile dimensions 13x12 mm
welded - COLOUR BLACK

For: ANGELO PO convection Oven electric FCV141E, FCV141EDM, FCV141EDS
ANGELO PO convection Oven gas FCV141, FCV141DM, FCV141DS

Adaptability:
MANUFACTURER CODE
37Q7530 ANGELO PO
37Q7531 ANGELO PO
37Q7530 SAGI
37Q7531 SAGI

We have available all models of gaskets for oven door ANGELO PO for industrial kitchens professional

Instructions and tips for the replacement/installation of the seals:

1) Remove the old seal from its seat

2) thoroughly Clean all of the debris and dirt both from the throat-snap-fit on the bearing surface with specific detergents

3) In the event of difficulties in inserting the gasket in the joint spraying/wetting with liquid soap

4) Mount the gasket starting from the corners in the sequence: (as in photo 1)

- First mount the 4 corners A-A1, B-B1

- Then the center between the points C-C1

- Now push the rest of the gasket starting from the center to the points C-C1 and D-D1

*CAUTION: if the seal has a hole, air vent, the side with the hole must be mounted in the bottom (as in photo 2)

*IMPORTANT: CHECK DOOR SEAL

- If the gasket is mounted correctly, steam should not result in a loss of steam

- In the "combi steam" to 300C, the door must be closed properly. Otherwise an adjustment is needed of the door.

Care and repeated cleaning during the day, greatly extend the life of the seals.