DOOR GASKET OVEN BLOG
General Info:
in the silicone elastomer
profile dimensions 27x15 mm
COLOR BLACK
SALES PER LINEAR METER
For: convection Oven C20, C2011, C40, C56, C6, C810, MBS06.11, MBS06.23, MBS10.11, MBS20.11, MBS20.21, MDS06.11, MDS06.23, MDS10.11, MDS20.11, MDS-R06.11E-N, MX2011, MX40, MXB20, MXB2011, MXB40, MXB56, MXB6, MXB810, P16, P56, P810, PMX16
Convection oven electric CNV06.11E
Adaptability:
MANUFACTURER CODE
8C0917 EMMEPI
04-GRN-001 BLOG
04-GRN-003 BLOG
GUARNIZIONE003 BLOG
We have available all models of gaskets for oven door BLOG, for industrial kitchens professional
Instructions and tips for the replacement/installation of the seals:
1) Remove the old seal from its seat
2) thoroughly Clean all of the debris and dirt both from the throat-snap-fit on the bearing surface with specific detergents
3) In the event of difficulties in inserting the gasket in the joint spraying/wetting with liquid soap
4) Mount the gasket starting from the corners in the sequence: (as in photo 1)
- First mount the 4 corners A-A1, B-B1
- Then the center between the points C-C1
- Now push the rest of the gasket starting from the center to the points C-C1 and D-D1
*CAUTION: if the seal has a hole, air vent, the side with the hole must be mounted in the bottom (as in photo 2)
*IMPORTANT: CHECK DOOR SEAL
- If the gasket is mounted correctly, steam should not result in a loss of steam
- In the "combi steam" to 300C, the door must be closed properly. Otherwise an adjustment is needed of the door.
Care and repeated cleaning during the day, greatly extend the life of the seals.